Ameriwood HOME 2456339COM Mode D'emploi page 13

STEP 6
3
(x1)
Hammer Block
H
H
3
Holes on
this surface
A
A
end view
Position and insert the locking bolts (7) of right rear leg (H) into edge holes of end panel (A) as shown.
Be sure both parts are positioned as shown. Place the hammer block on top of leg in each of the 2
locking bolt locations and give a firm strike to lock together. The locking bolt (7) will snap into the
locking sleeve (8).
IMPORTANT NOTICE: Once locked together, parts cannot be separated.
Note: A rubber mallet can be used in place of a hammer and hammer block.
13
ameriwoodhome.com