Bestron SUMMER BREEZE DDF35Z Manuel D'instructions page 14

OPERATION - General information
The description below corresponds to image 1 on page 2.
1. Fan blades
2. Fan housing
3. Motor housing
OPERATION - Assembling the fan
The description below corresponds to image 2 on page 2.
1. Attach the base to the base plate, using the click system.
2. Unscrew the locking ring (see figure 2A) from the shaft.
3. Fit the rear of the fan housing (2B) onto the motor-housing (2C), making sure that the openings are
aligned precisely with the lugs on the motor housing and that the grip is at the top.
4. Slide the locking ring (2A) onto the shaft, and screw it tight (clockwise).
5. Slide the fan blades (2D) onto the shaft and place the fixing knob (2E) on the shaft.
6. The rim (2F) has clamps. Carefully fit the rim around the rear half of the fan housing, making sure that
the housing falls into the upper clamp of the rim, so that you can connect the two halfs of the fan housing
with the nut and bolt (2G). Use a crosshead screwdriver.
7. Close the other clamps.
OPERATION - Ventilate
The description below corresponds to image 3 on page 2.
1. Set the fan on a level surface, such as a table.
2. Tilt the fan to the required angle (see figure 3). You can set the fan:
a. to blow horizontally (position a) or angled slightly downwards (position b). Tilt the ventilator housing
and motor housing to the required angle.
b. to oscillate from left to right (with a sweep of 75 °). This will ventilate much of the room. Press the
oscillation button on the motor housing fully in.
c. remain in the same position whilst the fan is turning. This will ventilate one area. Pull out the
oscillation button until you hear it click.
3. Put the plug into the wall socket.
4. Switch on the fan by pressing one of the three speed buttons.
a. Position '1', the fan operates at low speed.
b. Position '2', the fan operates at normal speed.
c. Position '3', the fan operates at high speed.
5. Stop the fan by pressing the stop button (position '0').
CLEANING AND MAINTENANCE
Over the course of time dust can accumulate between the spokes in the fan housing, and on the fan blades.
Always begin by trying to remove the dust with a brush and/or vacuum cleaner. If this does not remove all
the dust you can always dismantle the fan and clean it.
1. Remove the plug from the wall socket.
2. Loosen the bolt in the rim around the fan housing using a small crosshead screwdriver.
3. Remove the rim and the front half of the filter housing.
4. Hold the fan blades to stop them from turning, and unscrew the spinner by turning clockwise in the
direction of the 'LOOSEN' arrow. Remove the fan blades from the motor housing.
5. Remove the rear half of the fan housing by turning the locking ring at the centre of the housing
anticlockwise. Remove the ring and the housing from the motor housing.
6. Clean the dismantled parts and the base with a damp cloth. Dry thoroughly with a dry cloth.
7. Clean the motor housing with a dry cloth.
WARNING:
• Verify that the appliance is not connected to the power supply before you clean it.
• Never use corrosive or scouring cleaning agents or sharp objects (such as knives or hard brushes) to
clean the appliance.
Reassemble the fan using the procedure given under by 'Assembling the fan'.
4. Oscillation button
5. Stop button
6. Speed buttons
14 14
7. Power cord and plug
8. Base
9. Base plate
EN EN