Tool it LCD EXPERT 11 040755 Mode D'emploi page 5

The welding helmet EXPERT 11 complies with EEC directives 89/686 CEE. This confirmity is established in compliance with EN 175, EN 166, EN 168 and EN 379.
Notified bodies / organisations :
Cell :
Identification number : 1883
This welding helmet is delivered ready for use. For your protection, please read carrefully these instructions and consult with a qualified instructor prior to operation.
BEFORE WELDING
-Check that the welding helmet is in good condition and headband adjustment.
-Check whether the front cover lens, the front frame and filter are inserted and fixed in place. In case of anomalie, please proceed to its reconditionning.
-Make sure that the 2 sensors (4) and the cell (2) are not obstructed by dust or debris.
-Make sure that the protection films on both screens are removed.
-Check that the protection level matches your welding processes. Please refer to the following chart to help your choice (cf. welding process board)
OPERATION
The EXPERT 11 auto-darkening welding helmet switches from light to dark state when a welding arc is struck. The auto-darkening welding helmet switches back to the light
state when the arc stops.
1
PRECAUTIONS
• The welding helmet is suitable for use with virtually all welding processes except Oxy-Acetylene welding, laser welding and gas welding.
• Standard protective screens must be installed on both inside and outside surfaces of the module. Failure to use protective screens may constitute a safety hazard or result in
irreparable damage to the module.
HEADBAND ADJUSTMENT
The EXPERT 11 is equipped with a headband which can be adjsuted in multiple ways to suit the welder: width, height (1), longitudinal inclination (3) and adjustment (2).
MAINTENANCE
• Expiration date: No expiration date for this product but the state of the EXPERT 11 welding helmet must be checked before each use.
• The welding helmet must not fall down.
• Do not put any heavy tools/objects in or on the helmet in order not to damage the filter or the protective screens.
• The deterioration of the filter or its protective screen can reduce the vision field or the protection level. Replace the damaged parts.
• Do not use any tools or other sharp objects to remove any components of filter or helmet. Doing so may damage filter or helmet preventing proper function, possibly cau-
sing injury or cancellation of the warranty.
• Clean the filter with a clean cotton or with a special rag for lens.
• Clean and change protective screens on a regular basis.
• Clean the inside and the outside of the helmet with a neutral disinfectant product.
• Do not use any solvent.
Welding hood / Protection
screen :
2
1. LCD protection plate
4
2. Solar cell
3. Filter
3
4. Sensors
Clear shade 3
Dark shade 11
Filter dimension 119 x 98 mm
Reaction speed 0,0005 s
Power supply Solar
Weight 470 gr
Field of vision 100x49mm
Applications MMA 10>150 / TIG 10>175 / MIG-MAG 10>200 / Grind
Warranty 1 year
Application temperature -10°C / + 60°C
Storage temperature -20°C / + 70°C
3
EN
Identification number : 1883
1
2
5