Perel Tools SCAMSET2 Mode D'emploi page 2

4. Camera Selection & Picture Display
• Put the MODE selector in the MANU position to display the picture of C1 or C2 permanently
• Put the MODE selector in the AUTO to toggle automatically between the pictures of C1 and C2.
5. Features
• flat square screen with high resolution
• two channels for camera connection
• selector for choice between C1 and C2 (CAMERA)
• selector for choice between automatic or manual switching between the 2 camera pictures (MODE)
• automatic camera dwell time selectable (2 – 20 seconds)
• 10VDC/100mA power supply for camera (via monitor)
• 12V power supply for monitor
6. Caution
• Do not expose the device to rain or excessive heat or humidity
• Verify whether the connections are secure. If not, this will affect the result or even damage the device
• Do not open the housing or try to repair the device. Consult a qualified technician instead.
7. Specifications
a) Monitor
System
Screen Size
Scanning Frequency
Audio Output
Video Output
Audio Power Output
Resolution at Centre
Power Supply
Power Output
Power Consumption
b) Camera
Picture
CMOS sensor
Scanning System
Resolution
Shutter Speed
Camera Correction
Night Visibility
Microphone Sensitivity
White Balance
Current Consumption
Video Signal Output
The information in this manual is subject to change without prior notice.
SCAMSET2
CCIR/PAL
5.5"
15625KHz (H) x 50Hz (PAL) (V)
0.1Vpp (75Ω)
1Vpp (75Ω)
0.5W (8Ω)
300 lines
12V/1000mA
10V/300mA
15W
B/W
¼"
2:1 interlace
300 lines
1/50 – 1/6000sec.
automatic
1 to 2m (6 built-in IR LEDs)
1 to 2m
automatic
150mA
1Vpp (75Ω)
2 PEREL