◆
Manual defrosting
Please defrost the device at least every 6 months. When you open the door of the device
frequently, you need to perform the defrosting more often. Turn off the power but do not
unplug the power plug. Let the appliance then defrost manually. Pay attention to the
container for condensed water(K) and remove the condensed water during the defrosting.
15.3 Moving the appliance
Turn off the appliance first and then unplug the unit from the wall outlet.
Remove all content. Shurely tape down all lose items inside your appliance.
Tape doors shut. Be sure the wine refrigerator stays in the upright position during
transportation.
16 Troubleshooting
This chapter provides you with important notices with regard to operating the device.
Observe the following notices to avoid dangers and damages:
16.1 Safety notices
Attention
► Only qualified electricians, who have been trained by the manufacturer, may carry out any
repairs on electrical equipment.
► Improperly performed repairs can cause considerable dangers for the user and damages
to the device.
16.2 Fault indications and rectification of faults
The following table assists in localizing and rectifying minor faults.
Fault
Your device is not cold
enough or it does not reach
the adjusted temperature:
The light does not work.
Vibrations & too much noise
& door does not close
properly
LED could not display.
LED display error – Lo
Buttons are not functional
Compressor will not start
Check the temperature control setting.
External environment may require a higher setting.
The door is open too often. The door is not closed
completely.
The door seal does not seal properly. Defrost the device.
Contact customer service.
Check to assure that the wine refrigerator is level. Check
the fan. Components are loose. Device touches the wall.
The door is reversed and not properly installed.
The seal is weak. The shelves are out of position.
Contact customer service.
Room temperature is lower than desired temperature.
Possible Cause
37