Publicité
Les langues disponibles
Les langues disponibles
• The installation and assembly of this device in non-stationary setup locations (e.g. on
ships) must be carried out by specialist companies / electricians, provided they guarantee
the prerequisites for the safe use of this device.
• For energy saving reasons please ensure that the door is closed when the appliance is
turned on.
12.5.2
Feet
There are different feet (3 bigger feet and 1 small foot).
To level your appliance, adjust the small foot at the bottom of the appliance.
12.5.3
The handle installing
The wine cooler comes with one metal
stainless steel handle. To install simply screw
them to the door with the supplied screws.
To do this, slide the rubber seal on the back of
the door to the side to lay open the predrilled
holes. Use the included screws to install the
handle on the door.
Then reinsert the rubber seal in the correct
position.
Usual shelf
To remove a shelf: Remove all bottles from the shelves. Lift the shelf upwards and the gently
pull it out, (eventually untighten the screws).
Please note
► Ensure that the shelves are firmly engaged in place before storing any bottles.
► Spread your bottles out as evenly as possible over the shelves, so weight is not
concentrated in one point; and make sure your bottles will not touch the back of the
cabinet.
12.5.4
Storrage depending on kind of bottle and size. You
can remove each shelf to store larger bottles.
Lower shelf
Shelves
32
Publicité
