Kenwood KMM-BT522HD Mode D'emploi page 40

INSTALLATION/CONNECTION
Installing the unit (in-dash mounting)
Orientate the trim plate as
illustrated before fitting.
When installing without the mounting
sleeve
1 Remove the mounting sleeve and trim plate from
the unit.
2 Align the holes in the unit (on both sides) with
the vehicle mounting bracket and secure the unit
with screws (supplied/commercially available).
Use only the specified screws. Using wrong screws
might damage the unit.
36
ENGLISH
Hook on the top side
Bend the appropriate tabs to hold the
mounting sleeve firmly in place.
How to remove the unit
1 Detach the faceplate.
2 Remove the trim plate.
3 Insert the extraction keys deeply into the slots on each side,
then follow the arrows as shown on the illustration.
Do the required wiring.
( 37)
Dashboard of
your car
Part list for installation
(A) Faceplate
(B) Trim plate
(C) Mounting sleeve
(D) Wiring harness
(E) Extraction key
(F) Screws (supplied for
)