ROBLIN INSPIRATION 520 Notice page 5

1. Preferably use a reduced suction speed; only use the intensive speed when necessary.
2. A well ventilated kitchen allows the hood to function more effectively.
3. Clean the metal filters regularly to maintain their effectiveness.
4. A saturated filter is not effective and will only be fit for purpose for a short period of time.
Never leave unguarded flames under the hood when in operation. Never leave frying pans unattended as
overheated oil may
catch fire.
The accessible parts of the hood may become hot when it is used with cooking appliances.
To obtain maximum efficiency in the absorption of fumes or steam, activate the hood 5 minutes before and after cooking
food:
• the first speed is recommended for cooking at a moderated heat and for sauces.
• the second speed is recommended for sustained cooking, grilling and frying.
• the third speed is recommended for cooking that produces a lot of fats and steam
IF AN ELECTRICAL COMPONENT GETS DAMMGED, IT CAN ONLY BE REPLACED BY A REPAIR SHOP RECOG-
NISED BY THE MANUFACTURER, AS SPECIAL TOOLS ARE REQUIRED FOR THIS PURPOSE
• In the event of a malfunction, inform your fitter; he is required to check the appliance and its connection.
• Fully disconnect the appliance.
• Always demand the use of original replacement parts, Any failure to follow this recommendation may compromise the
safety of the appliance.
• When you order replacement parts, note down the appliance number recorded on the descriptive plate indicated inside
the hood.
• Only the appliance purchase invoice will be valid in execution of the contractual warranty.
(this warranty does not cover consumables such as: lights, filters, etc.)
Prevent the risk of fire by cleaning the hood according to the maintenance recommendations.
• Regularly clean the bodywork using detergents and non-abrasive products and a damp sponge.
• Never use dripping wet sponges or cloths.
• Do not put any object or your hands into the opening used as an air outlet system.
• Clean inside the body by filtering with a suction once a year.
• Check that the exhaust air is effectively flowing every 6 months.
• Observe your local regulatory recommendations in relation to the discharge of exhaust air.
• Do not exceed the prescribed power and do not change the type of lamp.
• It is essential to carry out a periodic cleaning metal filters by hand (with liquid detergent in warm water and rinse) or in
the dishwasher (every two months for normal use).
• filters for coal are to replace after a lifetime of 400 hours..
ADVICE ON ENERGY SAVINGS
DIRECTIONS FOR USE
NEVER BLAZE DISHES ON THE APPLIANCE.
GUARANTEE AND AFTER SALES SERVICE
MAINTENANCE
Disconnect the power supply cable for any electrical intervention.
GB GB