Publicité
Les langues disponibles
Les langues disponibles
Operator's Manual WS 463
Maintenance
In addition to the daily maintenance such as cleaning and
lubrication, the machine must be serviced. When it is time
for a service the text "time for service" is shown on the
display on the remote control. After 50 hours of cutting,
the machine should be serviced at an accredited Dimas
workshop. The saw should then be serviced after every
100 hours of operation. The service is important so that as
the user you have a machine that works as effectively as
possible for a long time.
Oil change cutting arm:
There is an oil plug for draining the oil located on the
cutting arm. This plug should be cleaned when changing
the oil. The new oil is filled through the hole where the oil
plug sits.
The cutting arm contains 1 dl of Dimas Oil 150, a trans-
mission oil of the type EP 150. The oil should be replaced
for the first time in connection with the first service. A 1 dl
bottle of oil is supplied when the machine is new.
Remark
Remember than oil can pose a hazard to
health and the environment.
Lubricating the feed motors:
There are two grease nipples on each saw unit. The feed
motors can be lubricated through these. (We recommend
lubricating with VEIDEC POWER LUBE or equivalent
grease every 50 hours of operation)
Adjusting the guide wheels:
In order for the saw to run stably and saw a straight cut,
the four guide wheels must rest against the rail and not
have too much play. When there is too much play
between the saw carriage and rail the guide wheels must
be adjusted:
The two marked guide wheels have eccentric axles and
by turning these the carriage is tightened onto the rail.
English - 15
Publicité
