Varan Motors NEGJH-04 Manuel D'utilisation page 36

5.
Store fuel and mixture in approved containers in
6.
Put a clear indication on the outside of the container to avoid mixing up with gasoline or other containers.
7.
Indicate the contents on outside of container for easy identification.
Fueling the unit
Note: ensure that fuel tank cap and its surroundings are clean. Clean If necessary.
1.
Unscrew and remove the fuel tank cap. Rest the cap on a dustless place.
2.
Put fuel into the fuel tank to 80% of the full capacity. Do NOT fill in tank to its maximal capacity.
3.
Fasten the fuel cap securely and wipe up any fuel spillage around the unit.
WARNING
1.
Never refuel with running engine or hot engine.
Stop the engine before and allow it to cool down before refueling the unit.
At that time, be sure to sufficiently agitate the mixed gasoline in the container.
2.
Select outdoor bare ground or well ventilated area for fueling. Never refuel in closed area.
3.
Move at least 10 feet (3 meters) away from the refueling point before starting the engine.
Installing the bit
WARNING! Work with safety gloves so as to avoid any injury on the sharp edge/point of the
accessory(*)
(*) Note : accessory = flat chisel bit, pointed chisel...
1.
Pull out the drill lock (Fig.2 pos.10), then turn it 180° to unlock it.
2.
Insert the bit into the drill seat then turn it 180° to lock it
3.
Make sure the bit is securely locked up.
WARNING!
IF EXCESSIVE VIBRATION OCCUR, IMMEDIATELY STOP THE ENGINE
Excessive vibration of the accessory indicates that it is not installed correctly. Stop the
engine and check the accessory.
A poorly inserted bit may cause injury or damage.
Engine
Warning! It is dangerous to use this product with broken, loosened or missing parts. Before starting
the engine, always check that all parts are assembled correctly.
Cold engine start
1. Feed fuel into the fuel tank and tighten the cap securely.
2. Rest the unit on a flat surface, and hold with firm grip.
3. Push the primer bulb (Fig.3) several times until overflown fuel flows out in the clear tube.
4. Move the choke lever (19) to the closed position.
5. While holding the unit handle (14) firmly with one hand, pull out the starter rope (1) quickly with the other
hand, until engine starts.
IMPORTANT : Avoid pulling the rope to its end or returning it by releasing the knob. Such actions can cause
starter failures.
6. Move the choke lever downward to open the choke.
7. Allow the engine to warm up for a several minutes before starting operation
Notes : During the first 24 hours of use, the workload should be in low-speed in order to extent the service life.
Varan motors
BCIE SARL, gruuss-strooss 28, 9991 Weiswampach, Luxembourg
NEGJH-04
compliance with local regulations.
T: 00352/26908036 – F: 00352/26908040