Getting Started - Varan Motors NEGJH-04 Manuel D'utilisation

GETTING STARTED

Unpacking
Remove product from its packaging.
Check that product and accessories are not damage.
Content
The unit package contains:
-
Power unit
-
Tools kit (spark plug wrench, screwdriver, hex wrench, Chain file)
-
Oil tank
-
Manual
Fuel
Warning !
1.
Gasoline is very flammable.
Avoid smoking or bringing any flame or sparks near fuel or refueling location.
2.
Make sure to stop the engine and allow it cool before refueling the unit.
3.
Select outdoor bare ground for fueling and move container at least 3m (10 ft) away from the fueling point
before starting the engine.
4.
Use an anti-oxidant added quality oil expressly labeled for air-cooled 2-cycle engine use
5.
Do not use BIA or TCW (2-stroke water-cooling type) mixed oil.
ASPEN
We recommend the use of Aspen 2 fuel.
This ready for use mixture contains no benzene or lead. It is distinguished by high octane and has the advantage of
always ensuring appropriate mixing ratio.
Aspen2 fuel is suitable for 2-stroke engines and ensures its durability.
Recommended Mixing Ratio
Gasoline 25 : OIL 1
1.
This engine is certified to operate on unleaded gasoline.
2.
Make sure to use gasoline with a minimum octane number of 89RON.
3.
If you use a gasoline of a lower octane value than prescribed, there is a danger that the engine temperature may
rise and an engine problem such as piston seizing may consequently occur.
4.
Poor quality gasoline or oils may damage sealing rings, fuel lines or fuel tank of the engine.
5.
It is best to use unleaded gasoline to reduce pollution of the atmosphere and thus contribute to the protection of
the environment and your health.
How to mix fuel
WARNING - Pay attention to agitation.
1.
Measure out the quantities of gasoline and oil to be mixed.
2.
Put some of the gasoline into a clean, approved fuel container.
3.
Pour in all of the oil and agitate well.
4.
Pour in the rest of gasoline and agitate again for at least one minute.
As some oils may be difficult to agitate depending on oil ingredients, sufficient agitation is necessary for the
engine to last long. Be careful that, if the agitation is insufficient, there is an increased danger of early piston
Varan motors
BCIE SARL, gruuss-strooss 28, 9991 Weiswampach, Luxembourg
NEGJH-04
T: 00352/26908036 – F: 00352/26908040