Publicité
Les langues disponibles
Les langues disponibles
Adjust lighting brightness
When you connect the appliance to the power supply, it is in the initial
state. You can then adjust the lighting brightness. To do this touch
and the lighting will turn on. Then touch and hold the same sensor for
a few seconds and lighting brightness will change. Hold the sensor for
a few seconds more and the lighting brightness will change again. The
lighting has several levels of brightness.
Adjust lighting colour
When in standby, touch and hold
and
2 seconds. The blinking "L"
(lighting) will appear on the display. Now use the + and – to set the
desired colour of light. To accept the desired colour, simply wait 3 sec-
onds. The colour range is from 3000°K (warm) to 7000°K (cool).
Off-Timer
Use Off-Timer to turn off the hood after a specified time. Use Off-Tim-
er to filter the fumes out of the air after cooking. Touch and hold
for 3 seconds to activate the Off-Timer at any time. The appliance will
automatically turn off after approximately 15 minutes.
Gesture control
When you plug in your appliance, gesture control is active and
indi-
cator is on. Touch
to turn off the gesture control. Touch
again to
reactivate gesture control.
You can use gestures to control the fan speed and lighting. When
gesture control is active, you can also control the appliance using the
touch sensors.
Gesture control works correctly when you move your open hand about
5–10 cm from the surface of the control panel.
Note: To adjust the fan speed you need to move your hand across the
sensors as shown on Figure 4, items 1a and 1b. The area over which
to move your hand is marked on the figures presented below in this
manual.
If activating a certain function (such as turbo speed) requires multiple
hand gestures, reposition your hand for another gesture away from the
control panel to avoid triggering the motion sensors). Hand movements
must not be too fast. Preferably, a single gesture should take about 1
second.
- 12 -
Publicité
