Porter Cable PCL180D Manuel D'instructions page 9

90550128 PCL180D 4/6/09
:
Drill may stall (if overloaded or improperly used) causing a twist. Always
expect the stall. Grip the drill firmly to control the twisting action and prevent loss of
control which could cause personal injury. If a stall does occur, release the trigger
immediately and determine the reason for the stall before re-starting.
INSTALLING AND REMOVING THE BATTERY PACK FROM THE TOOL
:
Make certain the lock-off button is engaged to prevent switch actuation
before removing or installing battery.
TO INSTALL BATTERY PACK: Insert battery pack
into tool as shown in figure C.
TO REMOVE BATTERY PACK: Depress the battery
release button as shown in figure D and pull battery
pack out of tool.
OPERATING INSTRUCTIONS
TRIGGER SWITCH & FORWARD/REVERSE BUTTON - FIGURE E
The drill is turned ON and OFF by pulling and
releasing the trigger switch (1) shown in
figure E. The farther the trigger is depressed, the
higher the speed of the drill. A forward/reverse control
button (2) determines the direction of the tool and
also serves as a lock off button. To select forward
rotation, release the trigger switch and depress the
forward/reverse control button. To select reverse,
depress the forward/reverse control button in the
opposite direction. The center position of the control
button locks the tool in the off position. When
changing the position of the control button, be sure
the trigger is released.
LED WORK LIGHT
When drill is activated by pulling the trigger switch (1), the integrated LED work light
(9) will automatically illuminate the work area.
11:00 AM Page 9
9
C
D
E
2
1