Control Panel - Elcoman KOBRA FLEXPACK PRO Mode D'emploi

Shred
PACKAGING AND INSTALLATION
Kobra FlexPack is designed exclusively to
transform used cardboard boxes into padded
filling material and padding mats either as
a packing/cushioning material or as a filling
material. Reading this manual will enable to
get the best perfomance from your KOBRA
FLEXPACK.
INTRODUCTION
The machine is delivered wrapped on a wooden
pallet to ensure it is not damaged during
transport. You will need:
- Hex key 13 mm
- Pliers or scissors
- Hammer
PACKAGING
Use the pliers or scissors to cut the straps (1)
and remove the cardboard (2) from the pallet

CONTROL PANEL

Your Kobra FlexPack is equipped with a high tech TOUCH SCREEN control panel. Simply touch the
control on the panel in order to activate the functions of the machine.
Touch the FORWARD (1) Tav. B button and the
FORWARD
machine starts the cutting knives.
Touch the STOP (2) Tav. B button and the machine
STOP
stops immediately.
Touch the REVERSE (3) Tav. B button and the device
REVERSE
puts the cutting knives into reverse.
The machine is equipped with a LOAD METER (4) Tav.
B that enables to check the processing capacity of
Kobra FlexPack. For a constant and efficient processing
capacity it is recommended to keep the LOAD METER
(4) Tav. B with only the first 4 blue LED on to avoid
unintended jammings.
In case of emergency, press STOP (8) Tav. C button to
stop all functions of the machine.
14
KOBRA FLEXPACK PRO
TAV. A, Page 12
(3). Now your shredder is attached to the pallet
by means of the transport bars (5).
Remove all the packing material protecting the
machine.
Remove the transport bars (5) using the hex key
13 mm as shown in figure.
Fix the slides (6) to the pallet with the nails (7)
supplied. Now you can start to push your Kobra
FlexPack off the pallet. Warning! Kobra FlexPack
should be taken off the pallet by at least 2
people.
INSTALLATION
For devices which can be unplugged, use an
easily accessible socket in the vicinity of the
device. Connect the power cable of Kobra
FlexPack to the mains. Your Kobra FlexPack is
now ready to operate.
TAV. B, Page 14
TAV. B
TAV. C
KOBRA FLEXPACK PRO
Shred
15