Publicité
Les langues disponibles
Les langues disponibles
Battery Charging
Charging the Installed Battery
1. Remove the charging port cover at the bottom of the stem. Make sure the
charging port is dry and free of dust.
2. Connect the charging adapter.
3. The battery is fully charged when the indicator light of the charging adapter turns
from red to green.
4. Close the charging port cover after charging the battery.
*The scooter cannot be turned on if it is connected to the charging cable, even if the
cable is unpowered. When turning on the scooter, please completely remove the cable.
Charging the Removed Battery
1. Remove the battery (→ Battery Removal).
2. Open the charging port cover at the bottom of the battery. Make sure the
charging port is dry and free of dust.
3. Connect the charging adapter.
4. The battery is fully charged when the indicator light of the charging adapter turns
from red to green.
5. Close the charging port cover after charging the battery.
Battery interface
Charging port
Only use the original charging adapter to charge the scooter.
13
Maintenance
1. Make sure the scooter is turned off and the power adapter is disconnected.
2. Wipe clean the scooter with a damp cloth. Never use lubricating oil on the body and
do not immerse it in water.
Storage
1. Fully charge the scooter before storing, and charge it at least once a month to
prevent premature decay of the battery capacity.
2. Do not charge the battery if the temperature is below 32 °F (0 °C).
3. Keep the scooter in a dry, ventilated, and cool area away from direct sunlight, rain,
and high humidity, and cover the scooter to protect it from dust.
4. The kickstand is designed to provide structural support, so avoid standing on the
scooter while the kickstand is down, as this can cause the kickstand to crack or break.
General Troubleshooting and Solution Guide
Problem
Cause
The scooter
The battery has run out.
will not
turn on.
The battery
The charging adapter
will not
is not connected to an
charge.
AC power source, or
the charging adapter
is damaged.
Solution
Recharge the battery.
1. Connect the adapter to an AC power
source. If the indicator light turns on, the
adapter is in good working condition. Then,
connect the adapter to the charging port
on the stem or the battery (the battery can
be detached for flexible charging).
2. If the indicator light does not turn on, the
adapter has broken down. Replace the
adapter.
14
Publicité
