Publicité
Les langues disponibles
Les langues disponibles
The charging adapter
is not properly
connected to the
charging port on the
stem or the battery.
The battery power is full
or the battery has
failed.
Cruise
The current speed is
control
below the minimum
cannot be
speed required for
activated.
cruise control.
The current speed is
not constant.
The stem is
The screws on the stem
loose.
folding spanner are
loose.
The scooter is set at
"non-zero" start and
has not been manually
The scooter
started.
cannot
accelerate.
The throttle is not
released.
Environmental Protection
Waste electrical products should not be disposed of with household waste. Please recycle
where facilities exist. Check with your Local Authority or retailer for recycling advice.
Check whether the connector of the charging
cable is fully inserted into the charging port on
the stem or battery.
1. If it is fully connected, then connection is
normal.
2. If it is not fully connected, please unplug the
cable and re-connect the cable to the
charging port.
After confirming that the charging adapter is
functioning, connect the charging adapter to
the AC power source and the charging port on
the stem.
1. If the indicator light turns red, then charging
is normal and the battery is in good working
condition.
2. If the indicator light turns green, then the
battery is full or has reached failure. In case
of failure, replace the battery.
Cruise control can only be activated when
travelling at speeds greater than 3.7 mph
(6 km/h). Increase speed to enable cruise
control.
Keep the current speed constant. Then, hold
the throttle in the same position for 6 seconds
to enable cruise control.
Tighten the screws on the stem folding spanner.
Ride the scooter for a short distance while
powering manually. When the scooter's speed
reaches 1.9 mph (3 km/h), the scooter can be
accelerated.
The throttle is equipped with an electric lock, so
it is required to completely press down the
throttle in order to accelerate the scooter.
15
Français
16
Publicité
