Publicité
Les langues disponibles
Les langues disponibles
Remote control - Changing the batteries
1. Open the cover on the battery compartment at
the rear of the remote control by pushing it in the
direction of the arrow and then lifting it.
2. Insert the supplied AAA batteries, ensuring that the
poles are in the right direction (indicator visible in
battery compartment).
3. Close the battery compartment again.
Connection
IMPORTANT: The TV set is designed to operate on
220-240V AC, 50 Hz socket. After unpacking, allow
the TV set to reach the ambient room temperature
before you connect the set to the mains. Plug the
power cable to the mains socket outlet.
VGA
13V dc /18V dc
SPDIF
Basic handling of the TV set
Power On/Off
To Switch the TV On
• Switch the "
" button on the rear left hand side
to position "|" so the TV will switch to standby mode.
Then the standby LED lights up.
To switch on the TV from standby mode either:
a. Press the On/Standby button, program +/- or a
numeric button on the remote control.
b. Press the middle of the "
By either method the TV will switch on.
Satellite
Aerial or Cable
DiSEqC
Switch
" button on the TV.
- 33 -
Switching the TV Off into Standby mode
• Press the On/Standby button on the remote control
or press the "
" button, so the TV will switch to
standby mode.
Switching the TV Off using the power switch
• Switch the "
" button to position 2 as illustrated,
so the TV will switch OFF.
To turn off the TV completely, remove the power
cord plug from the mains power socket.
NOTE: The mode is shown thanks to an LED. When
the TV is switched to standby mode, standby LED can
blink to indicate that features such as Standby Search,
Over Air Download or Timer is active. The LED can also
blink when you switch on the TV from standby mode.
Initial Installation
When turned on for the first time, the "language
selection" menu appears. The message "Welcome
please select your language!" is displayed in all
language options listed alphabetically.
Press the up/down arrow keys to highlight the
required language, press OK button to select. "First
Time Installation" appears. Use the right or left arrow
keys to set the required country.
Next, select Scan Encrypted and set as Yes if you
want to scan coded stations.
Publicité
