02 Initial Setup
When you turn on your TV for the first time, it immediately
starts the Initial Setup. Follow the instructions displayed on the
screen and configure the TV's basic settings to suit your viewing
environment.
Using the TV Controller
You can turn on the TV with the TV Controller button on the
lower-left corner of the back of the TV, and then use the Control
menu. The Control menu appears when the TV Controller button
is pressed while the TV is On.
To run an item on the menu, move the TV Controller button up,
down, left, or right to move the focus to it, and then press the TV
Controller button.
Control menu
Remote control sensor / Microphone switch
How to turn on and off the Microphone
On
Off
You can turn on or off the microphone by using the switch at the
bottom of the TV. If microphone is turned off, All voice and sound
features using microphone are not available.
• The position and shape of the microphone switch may differ
depending on the model.
• During analysis using data from the microphone, the data is
not saved.
03 Using the NFC on TV function
You can use the NFC on TV function to listen to your mobile
device sound through the TV speaker.
1. Unlock the screen on your mobile device.
2. Activate the NFC feature (Standard mode) on your mobile
3. Place your mobile device on the top of the TV where an NFC
4. Follow the instructions on the screens of the TV and your
5. When your mobile device is connected to the TV, the music
6. The selected media content is played through the TV speaker.
TV Controller button
• If the NFC on TV function does not work properly, repeat the
• Once the connection has been complete, keep touching the
• The NFC on TV function may not be supported depending on
• For the exact location of the NFC reader on your mobile device,
• This function is only available on NFC-enabled mobile devices
1
3
device.
mark exists.
mobile device to complete the setup.
being played on the device is automatically played by the TV. If
no music is being played on your mobile device, select a media
content item on the device.
– When the TV is connected to the Internet, Ambient Mode
is automatically entered, and then the selected media
content is played.
steps above.
mobile device against the NFC mark on your TV until the
mobile device and TV respond (it may take a few seconds).
your mobile device. Refer to the user manual of your mobile
device to check if it supports the NFC feature.
refer to the user manual of your mobile device.
with Android 4.1 or later installed.
2
4
English - 5