Makita ML010G Manuel D'instructions page 8

Battery indicator
This indicators show the battery in use or the remaining
battery capacity.
The indicators correspond to each battery as shown in
the figure.
XGT
Fig.5
► 1. Battery indicator
Indication of the battery in use
When turning on the appliance, the indicators of the
installed batteries light up.
Few seconds later, the indicator of battery currently in
use will light up.
Color of the indicator
Green
Red
Indication of the remaining battery
capacity
When the battery in use runs out, the appliance
switches to another battery automatically.
When switching the battery, the all indicators of the
installed batteries will light up.
Color of the indicator
Green
Red
When all of the batteries run out, the indicator of the last
one will blink in red.
1
LXT
Battery capacity
Battery capacity is remaining.
There is no battery capacity.
(Run out of battery)
Battery capacity
Battery capacity is remaining.
There is no battery capacity.
(Run out of battery)
Appliance / battery protection
system
The appliance is equipped with the protection system.
This system automatically cuts off power to extend
appliance and battery life. The appliance will automati-
cally stop during operation if the appliance or battery is
placed under one of the following conditions.
Overload protection
When the appliance is operated in a manner that
causes it to draw an abnormally high current, the appli-
ance automatically stops without any indication. In this
situation, remove and install the battery cartridge when
using with DC power, or push the breaker restart button
when using AC power. Then turn the appliance on to
restart.
Fig.6
► 1. Breaker restart button
Overdischarge protection
When the battery capacity becomes low, the LED
lights go out except a part of LEDs as illustrated. Then
approximately five to ten minutes later, the system auto-
matically cuts off power. In this situation, remove the
battery cartridge from the appliance and charge it.
Fig.7
8 ENGLISH
1