Publicité
Les langues disponibles
Les langues disponibles
TIN) in your app or scan the QR code. The device number can be
found on the sticker supplied or attached to the device.
•
Wait until pairing is completed.
If connecting was successful, the LED (A) lights up green. The
•
device is now ready for use.
•
If the LED lights up red, please try again.
•
Select the desired solution for your device.
•
In the app, give the device a name and allocate it to a room.
7
Operation
After setup, you can perform initial operating functions via the push-but-
ton rocker switch:
•
Short button press upper button The motor for the blinds/shut-
ters/awnings moves into the corresponding end position.
•
Short button press lower button (opposite direction): The motor
stops.
•
Long button press: The motor is controlled so that you can adjust
the slat position of the blind.
8
Troubleshooting
8.1
Command not confirmed
If at least one receiver does not confirm a command, the device LED
(A) lights up red at the end of the failed transmission process. The failed
transmission may be caused by radio interference (see see „11 General
information about radio operation" on page 38). This may be caused
by the following:
•
Receiver cannot be reached.
•
Receiver is unable to execute the command (load failure, me-
chanical blockade, etc.).
•
Receiver is faulty.
Operation
35
Publicité
