Costco WT17YL Mode D'emploi page 10

The flames should look like those in Figure 9. To clean the burner,
use a soft brush after the burner has cooled completely. Never use a
vacuum cleaner on the burner. It is recommended to store the fire pit
indoors during winter if it will be subjected to freezing temperatures.
The LP cylinder must be disconnected and removed from the
appliance before the appliance can be stored indoors.
Warning: If these instructions are not followed exactly, a fire or explosion may result causing
property damage, personal injury, or loss of life.
IGNITER BUTTON
1. Read instructions before lighting.
2. Push in on the control knob and turn to the ON position.
3. With the control knob pressed in, also push the igniter button to light the burner. Release
the control knob after 15 seconds. If the burner does not light, wait 5 minutes, repeat.
4. Adjust the flame to the desired height by using the control knob. See Figure 10.
Place the burner cover on the table top as shown in Figure11.
WARNING: BEFORE PLACING THE BURNER COVER ON, MAKE SURE
THE FIREPIT HAS BEEN SHUT OFF AND THE BURNER HAS
COMPLETELY COOLED DOWN.
MAINTENANCE
LIGHTING INSTRUCTIONS
BURNER COVER ASSEMBLY
Figure 10
Figure 11
10
Figure 9
CONTROL KNOB