Publicité
Les langues disponibles
Les langues disponibles
5 ASSEMBLY
5.1
8
Assembly
Warning
Danger of accidents Incorrect servicing will cause the brake system to fail.
–
Ensure that service work and repairs are performed professionally.
Warning
Danger of accidents Oil or grease on the brake discs reduces the braking effect.
–
Always keep the brake discs free of oil and grease.
–
Clean the brake discs with brake cleaner when necessary.
Note
Environmental hazard Hazardous substances cause environmental damage.
–
Dispose of oils, grease, filters, fuel, cleaning agents, brake fluid, etc., correctly and in compliance with
the applicable regulations.
Info
Assembly at an authorized specialist workshop is recommended.
502863-01
502864-01
502865-01
Condition
The brake caliper bracket can only be installed in combination
with the 270 mm diameter brake discs.
Enduro models
–
2
Remove screws
.
–
3
Remove cable tie(s)
–
Disconnect plug-in connector
–
Pull off brake caliper
–
6
Remove cotter pin
brake linings.
–
Pull the brake caliper bracket off of brake caliper
Motocross models
–
2
Remove screws
.
–
Pull off brake caliper
–
6
Remove cotter pin
brake linings.
–
Pull the brake caliper bracket off of brake caliper
Assembly
–
8
Take collar
off of the original and mount on brake cali-
1
per bracket
(included).
–
9
Remove bolts
from the original and mount on brake
1
caliper bracket
.
Guideline
Bolt, brake
caliper bracket
.
4
.
5
.
7
, pull out pin
, and remove the
5
5
.
7
, pull out pin
, and remove the
5
25 Nm (18.4 lbf ft)
Loctite
.
.
®
243™
Publicité
