Aqara RSD-M01 Mode D'emploi page 6

Device Installation
Scan the QR code below to watch the installation guide.
1 Choose the installation location.
First, remove the head cover of the device.
2 Select the plate according to the following plate-bead
matching relationship, and install it on the output sha of
the device.
3 Hang the bead chain on the plate of the device and pull it
down tightly (not too tight), keep the bead chain tight and hold
the device on the wall, and find a suitable installation location.
Beads with a
diameter of 3 - 4.5
mm (most popular)
√
Please make sure that the bead chain is
put in the selected installation position
properly and does not cross.
3
Beads with a diameter of 4.5
– 6mm, and beaded cords
with the connector (the
thickness of the connector
should be less than 6mm)
×