Aqara RSD-M01 Mode D'emploi page 10

Restore the
device to factory
settings & enter
network
configuration
status
To charge the device
When the USB cable is plugged in, the indicator will turn to blue
and blink for 3 times.
With the USB cable plugged in, the indicator will turn to red
until the battery is fully charged.
If the battery is fully charged, the indicator will be turned o .
Device Settings
Enter the homepage of the device, click the "..." icon in the
upper right corner to enter the device settings page, where you
can set the timer, automation, roller shade type, etc.
Product Specifications
Roller Shade Driver E1
Color: White
Product Model: RSD-M01
(R-Roller, S-Shade, D-Driver, M-Motor, 01-The First Generation)
Wireless Protocol: Zigbee 3.0 IEEE 802.15.4
Dimensions: 43×38.5×175 mm (1.69×1.52×6.89 in.)
Operating Temperature: -10°C ~ 55°C (14°F ~ 131°F)
Operating humidity: 0-95% RH, no condensation
What is in the box: Roller Shade Driver E1 × 1, Screw × 2,
Expansion Tube × 2, Double-Faced Adhesive Tape × 1, Spare
Rotating Plate × 3, USB-C to USB-A Cable × 1
Battery Type: Lithium battery (not replaceable)
Long press RESET button for 5 seconds, till
the indicator turns to blue and flashes
continuously:
At the moment, the device is restored to
factory settings and enters network
configuration status.
Network configuration status can last for 30
seconds, and in this period:
a.If the device is connected to the network
successfully, the indicator will stop
flashing.
b.If something goes wrong and the device
failed to connect to the network, the red
indicator will be on shortly and then o .
c. If there is no operation, the indicator will
be o a er 30 seconds and the network
connection will end.
7