EINHELL 4257796 Mode D'emploi page 12

5. Before starting the equipment
Warning!
Always remove the rechargeable battery
before starting any inspection or adjusting
work.
Warning:
Wear the necessary protective clothing, in
particular safety goggles, when working with
the cordless brad nailer.
Pay attention to the safety regulations.
•
Each time before starting work, check that the
magazine cover is securely fastened (Fig. 1/
Item 3). Clean the equipment thoroughly and
immediately each time after it has been used.
•
Each time before starting work, check that the
trigger catch functions perfectly and that all
screws are securely fastened.
•
Never tamper with the brad nailer.
•
Never dismantle or block any parts of the
brad nailer such as e.g. the trigger catch.
•
Never carry out any "emergency repairs" with
unsuitable means.
•
Proper brad nailer maintenance is required at
regular intervals in accordance with the infor-
mation supplied by the manufacturer.
•
Take precautions to prevent anything which
would weaken or damage the equipment, e.g.
from:
a) striking or engraving,
b) modifi cations which are prohibited by the
manufacturer,
c) guiding on templates made of hard material,
e.g. steel,
d) pushing across the fl oor,
e) using as a hammer,
f) any kinds of acts of violence.
5.1 Checking the trigger catch (Fig. 1)
Warning!
Remove the battery.
Check the trigger catch (6) each time before
use. The trigger catch must move freely without
jamming. The spring on the brad nailer head and
trigger catch must return the trigger catch to the
released initial position again. Never use the
equipment if the trigger catch is not working.
1. Remove the battery from the tool.
2. Remove the brad nails from the magazine
Anl_FIXETTO_18_50_N_SPK7_USA.indb 12 Anl_FIXETTO_18_50_N_SPK7_USA.indb 12
EN
(Fig. 4/Item 4).
3. Check that the trigger catch (6) can move up
and down freely.
4. Reinsert the battery in the tool.
5. Press the trigger catch (6) against the
workpiece without pressing the trigger (1).
The tool is not allowed to operate. Never use
the tool if it operates without the trigger (1)
being pressed. Risk of injury!
6. Remove the tool from the workpiece. The
trigger catch (6) must return to its released
starting position. Press the trigger (1). The
tool is not allowed to operate. Do not use the
tool if it operates. Risk of injury!
7. Press the trigger catch (6) against the
workpiece and press the trigger (1); the tool
will operate.
5.2 Loading the brad nails (Fig. 4-6/Item 4)
Warning!
Remove the battery.
•
When you fill the magazine (4), make sure
that you hold the equipment in such a way
that the nail discharge area is pointed neither
at yourself nor at anyone else.
•
To fill the magazine, press the magazine
release (2) and slide back the magazine
cover (3) as far as it will go (see Fig. 4).
•
Nails:
With the pointed end of the brad nails
downwards, press the brad nails against the
lower edge and push them to the front as
shown in Fig. 5 and 6.
Important!
It must be possible to move the magazine slide
without applying much force. Watch out for
jammed nails!
- 12 -
12.07.2023 09:05:29 12.07.2023 09:05:29