Dust Connection; Attach The Router To The Mounting - Jet JRT-1 Mode D'emploi

Attach the Fence Boards and Dust
Port
Fig 6
Attach the Fence Guard
Fig 7
Attach the Router to the Table
A) Direct Mount:
On certaint router types it is possible
to install the router directly to the
machine table
Remove the plastic protective plate
of your router (Fig 8)
Fig 8
Attach the router to the table by use
of supplied screws and nuts (Fig 9)
Fig 9
B) Use Mounting Plate:
In most cases it will be necessary to
attach the router to the mounting
plate first.
Holes must be drilled according to
your router´s hole pattern (Fig 10)
Fig 10

Attach the router to the mounting

plate by use of supplied screws and
nuts (Fig 10).
Attach the router with mounting plate
to the table by use of supplied
screws (Fig 11)
6
Fig 11
Attach the Table Insert
Fig 12
Assemble the Mitre Gauge
Fig 13

5.3 Dust connection

Before initial operation, the machine
must be connected to a dust
extractor. The suction should switch
on automatically when the router is
switched on.