FRIGOGLASS MAX-150 B Manuel D'utilisation page 12

When the cooler has small rotating castor wheels (optional feature) the brake must always be applied
when cooler is at the final position.
CASTOR BREAKS
MUST BE APPLIED
AT ALL TIMES WHEN
THE COOLER IS AT
THE FINAL POSITION
Cooler movement is recommended when it is empty. Rollers and castor wheels allow for
movements of loaded cooler over a distance of few meters, depending on the ground surface
and product load and should be done with appropriate precaution under the responsibility of the
users/movers only.
Take necessary precautions if lifting is needed during installation. Keep unauthorised people
away from the cooler until installation is completed.
iii. The merchandiser must stand upright for at least 1 hour after transportation and prior to start-up.
This gives the oil time to run back to the compressor after transit and installation.
iv. Allow a minimum gap of 100mm at the top, 100mm at the rear
and 50mm at the sides of the cooler for proper ventilation.
v. Do not place anything on top of the cooler.
vi. Handle placement instructions. Single door cooler (frameless door
option).
Open the door. Screw the handle from the back side of the door,
using the respective slotted cheese head screws and place
the handle spacer inside glass hole.
Check points
Level foot at the
middle
ENG
2
2
12