Publicité
Les langues disponibles
Les langues disponibles
Remote control
Inserting Batteries
1
Open the battery compartment
cover in the direction of the arrow.
Operation
•
Aim the remote control at the remote sensor and press control
buttons to operate.
•
Operate the remote control within a 30° angle on either side of
the remote sensor, up to a distance of approximately 15 feet.
BATTERY PRECAUTIONS:
•
Batteries should not be exposed to excessive heat such as sunshine, fire or the like.
•
The remote control unit uses infrared beams to transmit signals, so sunlight or fluorescent light on the remote
sensor may shorten operating distance.
•
Incorrect use of batteries may cause them to leak or burst. Read the battery warnings and use the batteries
properly.
•
Do not mix old and new batteries.
•
Do not mix alkaline, standard (carbon-zinc), or rechargeable, (Ni-Cd, Ni-MH, etc.) batteries.
•
Remove batteries if the remote control will not be operated for an extended period of time.
If this symbol is shown, it is only
valid in the European union.
TO USE AC POWER
1.
Connect the AC cord plug into this unit's AC INPUT jack.
2.
Connect the AC cord into an AC outlet.
NOTE:
•
Please make sure to insert the cord securely at both the LCD TV/DVD and the wall outlet.
•
The AC cord has a polarized type AC line plug. If the supplied AC cord does not match your AC outlet, contact
a qualified electrician.
WARNING:
•
DO NOT CONNECT THIS UNIT TO THE POWER USING ANY DEVICE OTHER THAN THE SUPPLIED AC
CORD. THIS COULD CAUSE FIRE, ELECTRICAL SHOCK, OR DAMAGE.
•
DO NOT USE WITH A VOLTAGE OTHER THAN THE POWER VOLTAGE SPECIFIED. THIS COULD CAUSE
FIRE, ELECTRICAL SHOCK, OR DAMAGE.
CAUTION:
•
WHEN THIS UNIT IS NOT USED FOR A LONG TIME, (E.G., AWAY ON A TRIP) IN THE INTEREST OF
SAFETY, BE SURE TO UNPLUG IT FROM THE AC OUTLET.
•
DO NOT PLUG/UNPLUG THE AC CORD WHEN YOUR HANDS ARE WET. THIS MAY CAUSE ELECTRICAL
SHOCK.
•
IF YOU NEED TO REPLACE THE SUPPLIED AC ADAPTER OR AC CORD, THE SPECIFIED ONE IS
RECOMMENDED. CONTACT CUSTOMER SERVICE AT 1-800-289-0984.
14
2
Install two "AAA" batteries,
paying attention to the
polarity diagram in the battery
compartment.
AC cord (supplied)
(continued)
3
Replace the compartment cover.
Approximately 15 feet
Power source
AC Outlet
Wider Hole
and Blade
AC 120V, 60Hz
Publicité
