Publicité
Les langues disponibles
Les langues disponibles
2.2 Function Setting
[Operation Instructions]
1.At the menu page, by touching "FUNCTION", it will go to the function setting page as shown in the figure
below.
2.At the function setting page, by touching the page turning key, it will go to the last or next page. When setting
is finished, by touching the menu page icon, it will directly back to the menu page; by touching the back icon, it will
back to the upper menu.
3.At the function setting page, by pressing the desired function, it will go to the corresponding setting page of
this option.
4.At the function setting page of some function option, by touching "OK", this setting will be saved; by touching
the "CANCEL" key, this setting will be canceled.
[Notes]
●At the function setting page with setting of any function changed, if the function is set to be memorized upon
power failure, this setting will be saved automatically and memorized upon next power-on.
●When there is submenu for the selected function option, by pressing it the control will go directly the setting
page of the submenu.
●The system is preconfigured by the installer. Some options may not be available or NA.
No.
Item
1
Mode
2
Fast hot water
FUNCTION Setting Page
Function Setting
Range
Default
Cool
Heat
Hot water
Cool + Hot water
Heat + Hot water
On/Off
ON Page
1. When the water tank is unavailable, then only
"Cool" and "Heat" are available.
2. For the heating only unit, only "Heat" mode, "Hot
Heat
water", and "Heat + hot water" are available.
3. It is defaulted to be "Heat" for the heat pumps and
heating only units and "Cool" for mini chillers.
When the water tank is unavailable, it will be
Off
reserved.
5
Remarks
Publicité
