BOMANN KB 6012 CB N Mode D'emploi page 30

Unpacking the Appliance
1. Remove the appliance from the package.
2. Remove all packaging material such as films, filler, cable
holders and cardboard.
3. Check the delivery contents for completeness.
4. Should the package contents be incomplete or damages
be found, do not take the appliance into operation. Take
it immediately back to the dealer.
NOTE:
Dust or production residues can be located on the appli-
ance. We recommend to clean the appliance as described
under "Cleaning".
Scope of Delivery
1 Cooler box
1 Power cord for alternating current (AC) 220 – 240 Volt
1 Car power cord for direct current (DC) 12 Volt
Notes for Use
General Notes
• Never place the appliance next to naked flames or other
heat sources.
• The lid is locked when the handle is pushed back and
when carrying.
• To open the cooler box, pull the handle forward.
• Do not open the lid more often than required. Do not
leave the lid open more often than is necessary. This will
influence the duration of the cooling or keeping warm.
• The duration of the cooling or keeping warm is also
dependent on the ambient temperature.
• The appliance is not suitable for permanent operation.
• The appliance can be connected to two different energy
sources.
- Alternating current: 220 – 240 V~ or
- Direct current: 12 V
• Use the switches COLD – OFF – HOT and
ECO – MIN – MAX to switch the appliance on and off,
or select an operation mode. Both switches must be
switched on in the desired position to ensure the func-
tion of the appliance.
• The respective indicator lamp will indicate the mode:
- Green for cooling
- Red for keeping warm
• Do not switch directly from one operating mode into the
other. If you would like to change the operating mode,
turn the appliance off. Wait about 30 minutes before you
switch it to the other operating mode.
Cooling
• You may keep cold foods cold for several hours.
• Turn the switch to the COLD position.
• The green control lamp lights up.
30
KB6012CBN_IM_01.2022
• For best results, only store already cooled food / bever-
ages in the cooler. Select a place of use that is protected
from direct sunlight.
Keeping Warm
• You may keep hot food / beverages warm for several
hours.
• Set the switch to the HOT position.
• The Peltier element will switch off and on at intervals to
maintain the temperature. The red control light will be lit
up when the Peltier element is in operation and when
the fan is running.
• The appliance is not designed for reheating. Cold food
will only warm up slightly after about 2 hours.
Operating Modes
NOTE:
To use the ECO or MIN functions, the appliance must be
connected to 220 – 240 V alternating current.
• In the MAX operating mode, cooling or heating is per-
formed at the highest level. Use this operating mode if
you want to cool or keep the food warm.
• The output is reduced in the operating mode ECO. Use
this operating mode if you want to cool or keep warm for
a longer period of time.
• In the MIN operating mode, cooling or heating is per-
formed at the lowest level. Use this operating mode for
food that has already been precooled or heated.
Using the Appliance
Make sure the appliance is switched off. The switch
COLD – OFF – HOT must be set to OFF.
Connection to the Alternating Current
1. Remove the power cord for the direct current, if nec-
essary.
2. Check to make sure that the mains voltage that you
want to use is 220 – 240 V~.
3. Plug the power cord for alternating current into the
"AC~ " socket on the appliance (see fig.)
4. Connect the appliance to a properly installed earthed
socket.
5. Set the switch to ECO, MIN or MAX.
6. Set the COLD – OFF – HOT switch to COLD for cooling
or to HOT for keeping warm.
13.01.22