Uline S-17353 Mode D'emploi page 2

DRUMS WITH FITTINGS
1. Check gaskets and ensure gasket is properly seated on plug.
2. Tighten to specifications listed in the table below, and do not cross thread.
PLUG TYPE
GASKET TYPES Buna
3/4" PLUG 12 ft-lbs
2" PLUG 20 ft-lbs
DRUMS WITH FITTINGS
1. Closure Instructions Rev. D are valid to close all product tested with and/or manufactured under Closure
Instructions Rev C. and Rev. B. Revisions are clerical and do not effect the actual closing of product.
2. A drum is properly closed only when all steps are completed in the matter and sequence indicated.
NOTE: If difficulties are encountered, do not ship the drum. Contact Uline Customer Service at
1-800-295-5510 for further instruction.
3. Under the applicable DOT regulations, any changes made to the method of closure or closure components
constitute a change in the design type of this packaging and invalidate the certification.
4. After filling and prior to transport, the shipper should verify the torque of all closures to determine if the effects
of heating and cooling or gasket relaxation have resulted in the need to re-tighten the closure.
5. Drums (other than the composites) are tested at room temperature.
PAGE 2 OF 6
CLOSURE INSTRUCTIONS CONTINUED
TRI-SURE STYLE
PE / PP
Poly or Teflon
(Composite Drums)
20 ft-lbs —
30 ft-lbs 10 ft-lbs
IMPORTANT
1-800-295-5510
RIEKE STYLE
(PLASTIC)
—
9 ft-lbs
20 ft-lbs
uline.com
RIEKE STYLE (STEEL)
Poly All Others
20 ft-lbs 15 ft-lbs
40 ft-lbs 30 ft-lbs
0124 IS-17353