Omcan MG-CN-0012-C Manuel D'instructions page 6

Maintenance
1. After operation, carefully clean the machine with a damp cloth, dry with a dry cloth.
2. Lubricate the gears at regular intervals by putting some food-safe oil into the gearbox every 6 months.
Be careful when handling the cutter, always use a sharp blade with the machine.
TROUBLESHOOTING
Problem
Meat not discharging smoothly.
REFERENCE
Item Number Model Number
11046 MG-CN-0012-C
Parts Breakdown
Model MG-CN-0012-C
Item No. Description
14649 Feed Pan for ERT-12
14650 Feed Stick for ERT-12
14654 Handwheel for ERT-12
78483 Discharge Plate for ERT-12
78484 Blade for ERT-12
14653 Arbor for ERT-12
14652 Feed Screw for ERT-12
78485 Barrel for ERT-12
14647 Fastening Screw for ERT-12
78486 Handle for ERT-12
78487 Set Screw for ERT-12
78488 Spring for ERT-12
23480 Drive Shaft for ERT-12
Cause
Front nut is too tight.
Discharge plate is blocked.
Blade is dull.
Description
Meat Grinder #12 Stainless Steel 0.7 HP /
522 W 110V/60/1
11046
Position Item No. Description
1 14656 Joint Sheath for ERT-12
2 14660 Oil Seal for ERT-12
3 14640 Bearing 80205 for ERT-12
4 14639 Bearing 80204 for ERT-12
5 14648 Worm Gear for ERT-12
6 14638 Bearing 80203 for ERT-12
7 23481 Spigot for ERT-12
8 23482 Sheath for ERT-12
9 23483 Elastic Washer for Axle for ERT-12
10 78489 Drive Box for ERT-12
11 78490 Body for ERT-12
12 78491 Bolt for ERT-12
13 14644 Oil Cover Screw for ERT-12
Slightly loosen.
Clean the discharge plate.
Sharpen or replace the blade.
Position Item No.
14 78492
15 14645
16 14646
17 14658
18 14655
19 78493
20 14637
21 14642
22 78494
23 14643
24 78495
25 78496
26
6
Solution
Manufacturer Model Number
ERT-12
Description
Rivet for ERT-12
Spring for ERT-12
Washer for ERT-12
Support Board for ERT-12
Foot for ERT-12
Socket Head Screw for ERT-12
Switch for ERT-12
Capacitor for ERT-12
Motor for ERT-12
Worm Shaft for ERT-12
Fastening Screw for ERT-12
Feed Pan for ERT-12
Position
27
28
29
30
31
32
33
34
35
36
37
38