Installation And Connection - CBE MTG LPG Mode D'emploi

GB
The LPG (liquid petroleum gas) and soporific gas detector, specially designed for the "caravaning" and
"boating" sectors, can detect the presence of these gases in the air.
This device has been specifically designed for the protection against ether (narcotic effect) and LPG.
An audible alarm informs about the presence of gas in the air before it affects people inside the
compartment.
The sensor signals the presence of LPG inside the compartment before its concentration reaches a tenth
of the minimum level necessary to prime an explosion.
The sensor has two different setting options that can be selected with the jumper placed on the back,
which allow to modify the sensor's sensitivity according to the use and the installation position chosen.
It may happen that the user shuts the sensor off because he is annoyed by the frequent or continuous
alarms, which are apparently not justified. The correct behaviour is instead the immediate and abundant
areation of the compartment and the resetting of the sensor by shutting it off and on again.
Each detector is tested and set for the reference gas; the sensor life is of about 10 years from its
installation. After this period the detector must be replaced.
WARNING: - The detector must be perfectly installed by specialised technicians.
- The incorrect use of the equipment invalidates the warranty and the manufacturer
declines any responsibility for damage to things or persons.

INSTALLATION AND CONNECTION

GA S-DETECTOR "LPG "
M T G
3
2
O N
Pos. "A"
OVERVIEW
RED
BLACK
WHITE
(max 50 mA)
Pos. "B"
5
1
BUZZER
–
–
S
12V