Publicité
Les langues disponibles
Les langues disponibles
Immediately prepare your mower for storage at the end of the season or if the unit will not be used for 30 days or more.
LAWN MOWER
When lawn mower is to be stored for a period of time, clean
it thoroughly, remove all dirt, grease, leaves, etc. Store in
a clean, dry area.
1. Clean entire lawn mower (See "CLEANING" in the
Maintenance section of this manual).
2. Lubricate as shown in the Maintenance section of this
manual.
3. Be sure that all nuts, bolts, screws, and pins are se-
curely fastened. Inspect moving parts for damage,
breakage and wear. Replace if necessary.
4. Touch up all rusted or chipped paint surfaces; sand
lightly before painting.
HANDLE
You can fold your lawn mower han dle for storage.
1. Loosen the two (2) handle knobs on sides of the up-
per handle and allow handle to fold down to the rear
(Figure 28).
2. Remove the two (2) handle knobs and carriage bolts
on sides of the lower handle and pivot entire handle
as sem bly forward and allow it to rest on mower
(Figure 29).
3. Reinstall knobs and carriage bolts to lower handle or
handle brackets for safe keeping.
NOTE: When setting up your handle from the storage
position, the lower han dle will require manually locking into
the mowing position.
IMPORTANT: WHEN FOLDING THE HANDLE FOR STORAGE
OR TRANSPORTATION, BE SURE TO FOLD THE HANDLE AS
SHOWN OR YOU MAY DAMAGE THE CONTROL CABLES.
STORAGE
FOLD
FORWARD
FOR
STORAGE
1. Operator presence control bar
2. Upper handle
3. Handle knob
4. Lower handle
1. Knob
2. Bolt
3. Handle bracket
20
1
Figure 28
2
1
Figure 29
MOWING
PO SI TION
2
3
4
3
Publicité
