JBM 53786 Guide D'utilisation page 4

EN
INSTRUCTION MANUAL
PRODUCT'S PRESENTATION
This product has been designed to disinfect the
air in rooms, using ozone (O3) to oxidize almost
any particle (including viruses, bacteria, organic
and inorganic compounds).
SAFETY INSTRUCTIONS
For sterilization, please only use in unoccu-
pied space.
Ozone with high concentration has adverse
effects on human health. Therefore, the use of
ozone for air disinfection is generally not recom-
mended if people are around.
Therefore, air disinfection using ozone
should be restricted to unoccupied room only.
It is important that the ozone air purifier be
properly grounded to avoid potential shock.
OPERATION
Make sure the area is unoccupied before using.
Turn the timer clockwise to set the time you
need the product to run.
After setting the time, the indicator light will turn
on and the generator will begin to work.
When time is up, the indicator light will turn off
and the generator will stop working.
If you need the air purifier to run indefinitely, turn
the timer clockwise to the "hold" position.
To power off the product, set the dial to the "off"
position.
If you want to turn off the generator, press the
power on button and the generator will stop wor-
king.
Before entering in a disinfected area, you should
wait for approximately one hour to make sure
ozone levels are not harmful to human health.
To know the exact concentration of ozone in the
air, you can use an ozone meter (REF.53802).
If you need to enter the area while disinfecting
it, make sure you wear suitable personal pro-
tective
equipment.
Recommended operating time for different room
volume:
50m³ 100m³ 150m³ 200m³
20min 40min 60min
MAINTENANCE
Ozone plate:
Clean the ozone plate about once every month.
It is better to replace it every half year (REF.
14775).
Clean or change the ozone plates as follows if
the ozone output is weak.
Press the handle to release the plate and draw
it out from the generator.
Clean it with water or replace with a new one.
Before placing the plate, make sure it is dry.
Air-filter:
Air-filter is washable.
You can clean if dirty.
TROUBLESHOOTING
If you suspect a problem with your unit check
the following:
1. Unit is plugged in properly and turned on.
2. Wall outlet is active.
3. Ozone plate is clean and dry without any
cracks.
4. Fuse is installed properly and in good con-
dition.
If the fan is still not operating or no buzzing
sound is detected when operating, please con-
tact with your provider.
· 4 ·
REF. 53786
300m³ 500m³
80min 100min 120min