Publicité
Les langues disponibles
Les langues disponibles
4. Enclosure Installation
Caution! Read All Instructions and Warnings Before Installation!
Warning: Rack enclosures can be extremely heavy. Do not attempt to unpack, move or install the enclosure without assistance. Use extreme caution
when handling the enclosure and be sure to follow all handling and installation instructions. Do not attempt to install equipment without first
stabilizing the enclosure.
4.1 Preparation
The enclosure must be installed in a structually sound area that is able to bear the weight of the enclosure, all the equipment that will be installed in the
enclosure and any other enclosures and/or equipment that will be installed nearby. Before unpacking the enclosure, you should transport the shipping container
closer to the final installation location to minimize the distance you will need to move the unit after the protective packaging has been removed. If you plan to
store the enclosure for an extended period before installation, follow the instructions in the Storage and Service section.
You need several tools:
• Level
• Phillips-head Screwdriver
• Appropriate tools for wall mounting
4.2 Unpacking
1
Move shipping pallet to a firm, level surface.
2
Remove the corner protectors and save all packing materials for later use unless you are certain they will not be required. Packing materials are recyclable.
3
With one person on each side, carefully lift the enclosure off of the pallet and place on a firm, level surface.
4
Examine the enclosure for any damage or loose parts. Confirm all parts are present. If anything is missing or damaged, contact Tripp Lite for assistance. Do
not attempt to use the enclosure if it has been damaged.
4.3 Placement
If using the optional casters, you can use the casters to move the enclosure for a short distance over a level, smooth, stable surface by pushing it from the front
or rear (not the side panels). Do not attempt to roll the enclosure over long distances. The enclosure should be moved close to its installation location inside its
shipping container before it is unpacked. Warning: Use appropriate equipment and follow all applicable safety procedures and regulations.
Warning: Never attempt to lift or install without adequate help.
4.4 Ground Connection
All parts of the enclosure are grounded to the frame of the enclosure. Connect your facility's earth ground
connection to the provided ground stud
enclosure to earth ground separately. Do not use the enclosure without an earth ground connection.
Use at least two people to unpack the enclosure.
Do not try lifting the enclosure alone.
A
using an 8 AWG (3.264 mm) wire. Warning: Attach each
You also need the following hardware:
• Appropriate hardware for wall mounting (not included)
Note: The hardware used in mounting the enclosure must be able to withstand
the weight of the enclosure and all mounted equipment. For the weight of the
enclosure and its capacity, see the specifications on page 8.
A
EARTH
GROUND
4
Publicité
