Publicité
Les langues disponibles
Les langues disponibles
Start-up
You have received a completely assembled lifting magnet and detailed operating manual. Please check the
condition of the goods upon receipt for any damage incurred during transport, and make sure the delivery is
complete. If you have any problems, please contact the authorized reseller or manufacturer immediately.
Be sure to read the operation instructions completely before using this magnet for the first time!
1. The lever is facing upwards. The lifting magnet is deactivated.
2. Follow the safety instructions. Clean the work piece and the lower magnetic plate of the lifting magnet.
3. Position the lifting magnet at the center of gravity of the load. The lifting magnet is slightly magnetized in order
to assist in positioning the magnet (e.g. when used in a vertical or other forced position).
4. Align the lifting magnet according to the desired application.
5. Press the lever down until it is fully engaged in the ON position. Make sure that the safety tab is securely locked
in place.
6. Move the load hook to the required position and lift the load about several inches as a test lift to check for
excessive deformation and to verify adequate magnetic holding force. Do not place any part of your body under
the material at any time during lift. Ensure that only one piece is being lifted and that the load is safely held.
Refer to ASTM B30-20 and / or BTH-1 for more detail.
7. Now move your load slowly and smoothly. Avoid swinging or jarring.
8. After the load has been set down completely and safely, you can deactivate the lifting magnet. To do this, press
the safety tab using the heel of your hand and move the lever upwards into the OFF position.
6
Publicité
