Bossini Flat D48000 Instructions D'installation Et D'entretien page 14

FLAT Slide rail bar with incorporated water elbow.
The Flat Slide rail bar in brass is 1100 mm in length and incorporates a water elbow into its bottom or top
support, according to your needs (Fig. A). The side supports are adjustable, thus allowing the rail to be
mounted in any position, to perfectly adapt to any pre-existent holes. Max drill distance between centers:
1000 mm.
GB
INSTALLATION
- Check position of water elbow (Fig A), identifying one of the two installation solutions possible
(A or B).
- Mark wall support (5) fastening point (Fig. B). Make sure that the rail is at a right angle with the
floor.
- Drill the holes with an Ø 8 mm drill bit (Fig. B)
- Mount the support (5) with the yoke turned upwards. Screw in the water elbow (11) complete
with flange (12) (Fig.C)
- Assemble the rail by mounting:
-Sliding support (2) with yoke turned upwards
-Central sliding support (7) keeping conical coupling left.
-Bottom water elbow support (14) (Fig. D)
- Insert the spring (4) followed by the bushing fasteners (3) in the bracket seat (2), sliding them
until they are snugly lodged into the seat (Fig.D).
- Insert the support (2) into the flange (5) and the support (14) into the wall water elbow
(11). (Fig. E)
- Lock the support (2) by pushing the spring (4) and twisting the bushing fastener (3) clockwise
until the assembly snaps firmly into place. (Fig. E)
- Mount support (14) to the water elbow (11) by screwing in the dowels (13) (Fig. E)
- Mount the showerhead (9) and hose (8)
RECOMMENDATIONS FOR PROPER USE
Proper use of this product will allow you to avoid damages to the bathroom environment.
* To prevent impurities or debris from getting inside the product and causing functional problems,
always flush out the system before connecting it to the supply pipes. It is recommended to install
the filter at the system's water intake.
* To keep the diffuser clean and prevent lime scales from clogging the diffuser, we advise that you
periodically rub the silicone nozzles to free them of the lime deposits.
CLEANING
Dear Customer,
Congratulations for choosing a Bossini product and we thank you for the trust you have given us. To
keep the material's appearance as long as possible, a few guidelines must be followed.
Cleaning metal parts: water contains calcium that deposits on surfaces and forms unpleasant
spots. For routine cleaning, simply use a damp cloth with a little soap, rinse and dry. Calcium spots
can therefore be avoided by drying after use.
Important note: Using only a soap-based detergent is recommended. Never use abrasive detergents
or disinfectants or those containing alcohol, hydrochloric acid or phosphoric acid, Bleach, chlorine etc
Cleaning the rubber nozzles: the showerhead is equipped with the "Easy-Clean" system with silicon
nozzles. Calcium is a shower's worst enemy and that is why Bossini proposes theEasy-Clean" system.
These silicon nozzles are extremely heat resistant and with hot water they dilate, thus detaching the
first layer of calcium. Moreover, periodically rubbing the silicon nozzles manually easily gets rid of
calcium. With one simple gesture, your shower is always perfect.
Dear Customer, we would like to remind you that the warranty on our product's surface is not valid
14
D48000