Télécharger Imprimer la page

MW TOOLS HPK204060L Mode D'emploi page 2

Masquer les pouces Voir aussi pour HPK204060L:

Publicité

Waarschuwingen
NL
• Gelieve deze handleiding aandachtig te lezen en grondig te begrijpen voor het toestel te gebruiken.
• Het toestel dient enkel en alleen als ophefapparaat, en niet als ondersteuning. Het moet altijd met
steunblokken of garagestands gebruikt worden. De bediener mag in geen enkel geval een voorwerp
opheffen zonder steunblokken eronder te plaatsen na het opheffen met de hydropneumatische krik.
• Het toestel moet op een stevige ondergrond met een voldoende draagvermogen gebruikt worden. Het
mag niet op een oneven of hellende ondergrond gebruikt worden, zodat de opgeheven voorwerpen niet
kunnen vallen of glijden, vooral de voertuigen. Plaats ook een anti-slip wielkeg onder het wiel voor een
voertuig op te heffen.
• Voor veiligheidsredenen moet de luchttoevoer uitgeschakeld worden na het opheffen.
Avertissements
FR
• Veuillez lire attentivement et bien comprendre le manuel d'utilisation avant d'utiliser l'appareil.
• L'appareil sert uniquement comme engin de levage, et non comme support. Il doit toujours être utilisé avec
des blocs supports et des chandelles. L'utilisateur ne peut en aucun cas soulever un objet sans placer de
support après le levage de l'objet au moyen du cric hydropneumatique.
• L'appareil doit être utilisé sur un sol résistant, ayant une capacité de charge suffisante. Il ne peut pas être
utilisé sur un sol incliné ou inégal, pour éviter que les charges levées ne tombent ou ne glissent en bas du
cric, en particulier les véhicules. Veillez aussi à placer une cale antidérapante sous la roue avant de lever
un véhicule.
• Pour des raisons de sécurité, l'arrivée d'air doit être coupée après les opérations de levage.
Warnings
EN
• Please read the operation manual carefully and comprehend it thoroughly before using the product.
• The product only serves as a hoisting tool but not a supporting tool. It shall work with security bracket
and brace. Operators are not allowed to lift objects without placing security bracket and brace after the
hoisting of the pneumatic hydraulic jack.
• The product shall be used on solid ground with supporting capacity. It shall not be used on an inclined
or uneven ground to avoid the objects to be left from shifting or side slipping, in particular, when lifting
vehicles. Please ensure that anti-slip and anti-shifting backers for the wheel are placed before lifting.
• For security reasons, the air supply pipe shall be shut down after the pneumatic jack lifts.
2
M1.3.HPK.NLFREN - 20052020

Publicité

loading