Beamz Panther 40 Led Spot Manuel D'instructions page 7

MASTER SLAVE FIXTURE
1. Connect the (male) 3 pin connector side of the
DMX cable to the output (female) 3pin connector
of the first fixture.
2. Connect the end of the cable coming from the
first fixture which will have a (female) 3 pin
connector to the input connector of the next
fixture consisting of a (male) 3 pin connector.
Then, proceed to connect from the output as
stated above to the input of the following fixture
and so on.
3. Press the MODE button you see on display
"SET" press "ENTER" use the "UP" or "Down"
button until "MAAL" is displayed, press "ENTER"
Either "MAST" or "ALON will be displayed.
4. Press the UP or DOWN buttons until your desired setting is displayed, press ENTER to confirm.
NOTE: In a Master/Slave configuration you can set one fixture to Master and then set the next fixture to "ALON",
the fixtures will move synchronously.
REMOTE CONTROL
With the IR remote, you can operate the moving head easy and you have many functions.
To control the fixture you must aim the remote at the front of the fixture and be no more than 30 feet
away.
STAND BY
To activate remote controller you have to switch the device in standby with the "STANDBY" key on the
remote, the display now shows STOP.
FULL ON
You can then turn on the unit by pressing the "FULL ON" key, now the LED will light up. The display now
show UHI.
The operation with the remote continued as follows:
GOBO Set:
Press "GOBO" and then press one of the number keys, select the correct gobo.
Color Setting:
Press "COLOR" and then press one of the number keys, select the color.
Strobe Setting:
Press "STROBE" and then press on of the number keys, select Speed.
With the keys "DIMMER +" and "DIMMER -" you can adjust the light intensity.
Setting the program:
Press the "SHOW" button followed by a number buttons for wanted program.
You can now press the "SOUND NO" key to make the device sound activated.
By "SOUND OFF" button the device switches back to auto mode.
UHI setting
Press the "UP" or "Down" button you see on display "UHI" press "ENTER" use the
"UP" or "Down" button until "SCN" is displayed, press "ENTER". You can the Dim,
Stb (Strobe), Pan, Panf (Pan fine), Pans (Pan speed), Tilt, Tilf (Tilt fine), Tits (Tilt
speed), Colr (Color) or Gobo change.
If you pan or tilt fixture change, the fixture always goes to this position. By default
state fixture on 128 (home position). Use the "UP" or "Down" button to adjust.
ENTER ....
MODE
UP
DOWN
UP
DOWN
....
UP
DOWN
ENTER
MODE
ENTER
MODE
UP
DOWN
ENTER
MODE
UP
DOWN
UP
DOWN
UP
DOWN
UP
DOWN
UP
DOWN
UP
DOWN
UP
DOWN
UP
DOWN
UP
DOWN
7