Palram Palermo 3000 Mode D'emploi page 3

IMPORTANT
Please read
these instructions carefully before you start to assemble this product.
Please
carry
out the
steps
in
the order set out
in
these instructions.
Keep these
instructions
in
a
safe place
for future
reference.
Care
and Safety advice
Please
follow the instructions
as
listed
in
this manual.
Sort the parts and check against the contents list.
For safety purposes we
strongly recommend the product to
be assembled by at
least
two people.
Some parts have metal edges. Please be careful when handling components.
Always wear gloves, shoes and safety goggles during assembly.
Do
not attempt to
assemble the Gazebo
in
windy
or
wet conditions.
Dispose
of
all
plastic bags safely
-
keep them away from children's
reach.
Keep
children away from the assembly
area.
Do
not attempt to assemble the Gazebo if
you are
tired,
have
taken drugs,
medications or alcohol, or if you
are
prone to dizzy
spells.
When using
a
stepladder
or power tools, make sure
that
you are
following
the
manufacturer's safety advice.
Do
not climb or stand on the roof.
Heavy articles should
not
be leaned against the poles.
Keep
roof
and
gutters
clear
of
snow,
dirt
& leaves.
Heavy snow load
on
roof
can
damage the Gazebo making it unsafe to
stand below or nearby.
This
product
was designed and produced to be used
as
a
Gazebo only.
If color was scratched during assembly it
can be
fixed
with
the
following
tints:
Grey
-
RAL
7012
»
Cleaning instructions
In
order to
clean
the
Gazebo, use
a
mild detergent solution and
rinse
with
cold clean water.
Do
not
use
acetone, abrasive cleaners, or
other
special detergents to clean the panels.
»Tools
&
Equipment
T001
(Supplied)
During Assembly
During assembly
use
a
soft surface below the parts to avoid scratches
and damages.
When encountering the information icon, please refer to the relevant
assembly step for additional comments and assistance.
Steps 3-12:
It
is
recommended to
use
a
carton or other soft material under the lowered
corner
in
order to avoid scratches and peeling of paint.
Step 10:
Optional
-
if
you wish to add curtains
- Please
thread the plastic clips through
the
rail
in
each
profile
in
order to
hang
additional curtains (not supplied).
Add clips according to the specific quantity of curtain
rings.
Steps 10a+12a:
Please
note that threading of the
screws
should
be
done from the outside
Steps 12+14:
Please
note that threading of the
screws
should
be
made from the bottom
up.
Step 15b:
Please
add silicone on the inner
area
of part #8327
as
illustrated
Step 21a:
Please
drill holes
in
the panels to be located precisely parallel to the holes
in
profile #7663.
Step 22:
Please level
the profile's legs and adapt
screws
and plugs to your specific
ground type.
Attention
Screws and plugs are not supplied.
Please
tighten
all screws
when completing assembly.
Anchoring this product to the ground
is
essential
to
its
stability
and
rigidity.
It
is
required to complete this
stage in
order for your warranty to
be valid.