Taurus TS60IXAL Mode D'emploi page 12

 4. Place the one-way valve in the hood.
 5. Install the exhaust pipe.
FURNITURE FIXING:
 1. Drill 4 holes of 6 mm diameter in the bottom
of the furniture.
 2. Place the one-way valve in the extractor
hood, then install the hood on the bottom of the
hanging unit, tighten the hood with the 4
screws included.
 3. Install the exhaust pipe.
 NOTE: If you don't have an outlet to the
outside, the exhaust pipe is not necessary and
the installation is the same as before skipping
the part of the pipe (recirculation mode).
 You will need two carbon filters to trap odours,
they are not included.
 To install the carbon filters, remove the grease
filters as explained above, plug the filters into
the unit and turn them clockwise on both sides
of the motor, as shown below:
 Make sure the filter is securely locked.
 NOTE: When the carbon filter is connected, the
suction will be lower.
MODES
 The device has 2 installation modes:
Recirculation mode and extraction mode.
EXTRACTION MODE:
 The extraction mode expels the air to the
outside. This mode guarantees high
performance, high capacity and low noise level.
RECIRCULATION MODE:
 The recirculation mode removes odours by
means of a carbon filter and reintroduces the
air into the kitchen. This mode is suitable for
rooms without extraction ducts, saves air and
prevents thermal losses to the outside.
 For this mode, you need to obtain the carbon
filters and install them as explained in the
installation part, they are not included.
E N