Publicité
Les langues disponibles
Les langues disponibles
Quick
Connector
Tool
Quick Coupler
!
!
!
Material
adjustment
Pattern
adjustment
Air volume
adjustment
Fig.7
SETUP & OPERATION
Quick
Connector
Quick
Coupler
Air Hose
ASSEMBLY & PREPARATION
1.
After unpacking the product, inspect carefully for any damage that may have
occurred during transit. Make sure to tighten fittings, bolts, etc., before putting
unit into service.
2.
Thoroughly mix and thin paint in accordance with the paint manufacturer's
instructions. Most materials will spray readily if thinned properly.
3.
Strain material through filter, cheese cloth or a paint strainer before pouring into
spray container.
4.
Fill the container about ¾ full and start the air compressor.
WARNING! DO NOT EXCEED maximum pressure of HVLP spray gun or any
other parts in the compressor system.
5.
After connecting spray gun to air supply, please make sure that the fluid cap,
container and air hose have been connected tightly to reduce risks of leaks.
6.
Set up a piece of cardboard or other scrap material to use as a target and adjust
for best spray pattern.
WARNING! Never aim or spray at yourself or anybody else, which could cause
serious injury.
7.
Test the consistency of the material by making a few strokes on a cardboard
target. If material still appears too thick, add a small amount of thinner. THIN
WITH CARE! Do not exceed paint manufacturer's thinning recommendations.
ADJUSTMENTS
WARNING! The desired pattern, volume of fluid output, and fine atomization can
easily be obtained by regulating the pattern adjusting knob, material (PAINT)
adjusting knob and air adjusting knob.
Pattern adjustment: Turning the pattern adjusting knob to the right will make a
round spray pattern round, or turning it left will make an elliptic spray pattern.
Material (paint) adjustment: Turning the paint adjusting knob clockwise will
decrease the volume of fluid output and turning it counter-clockwise will increase the
fluid output.
Air volume adjustment: Turning the air adjusting valve clockwise will decrease the
air volume and turning it counter-clockwise will increase the air volume.
Filter
Lubricator
Regulator
Air
Compressor
Cut-off
valve
Fig.6
19
Publicité
