Standard Parameters; Operating Modes - Hama N300 Mode D'emploi

4. System Requirements:
Note that your computer or the wireless device in
question must be equipped with a WLAN network card/
USB stick or an integrated network adapter with an RJ45
LAN interface.
5. Controls and Display
5.1 On/off switch
Pressing the on/off switch (1) will switch the device on
or off.
5.2 Network port
You can connect your PC or console to this network port
in order to provide these devices access to your WLAN
network device.
5.3 WPS button (6)
This button can be used to connect/link the repeater
to your WLAN router using WPS; it can also be used
to reset the repeater to the factory settings in case of
a malfunction. To make a connection/link using WPS,
please read the section Start-Up Using WPS.
Restoring the factory settings:
If a connection to the configuration program cannot be
established, reset the device to the factory settings by
pressing the WPS button for approx. 6 seconds.
5.4 LED indicator
Status LED
Constant
Repeater is switched on
light
Off Repeater is switched off
Flashes Repeater is not connected to a
slowly network
Flashes Repeater is connecting to a
quickly network

5.5 Standard parameters

URL http://ap.setup
IP address 192.168.10.1
Password admin
SSID Wireless-N
None / No key is necessary for
WiFi key
connection
6. Getting started

6.1 Operating modes

The repeater basically supports two different operating
modes:
A) Repeater mode:
The repeater strengthens your wireless network; it is
connected to the existing router/access point via WLAN.
Here, the SSID and password of your existing network
are copied.
Note
The setup described in this quick guide relates solely
to the repeater mode!
3