humble Two Manuel D'instructions page 3

EN
Product information Humble Two:
The Humble Two is a wireless lamp, available in multiple finishes, with a built-in
rechargeable battery. The light source is a 3V 1W LED filament emitting 2700K (warm
white) light. A fully charged lamp remains lit for at least 24 hours (at full brightness) but
can last up to 96 hours (at the lowest brightness).
WARNING: READ CAREFULLY BEFORE USE!
Place the lamp on a dry, horizontal surface. Do not expose the lamp to excessive heat. The
lamp is intended for indoor use, but can be used outdoors without an adapter. Protect
it against water and store inside after use. Check the voltage of your power supply; the
voltage must be between 100 and 240V AC. Check the cable provided for damage.
When the lamp is switched on, do not stare at the light source at full brightness, as this
may cause eye damage. The lamp is not a toy: keep away from children.
Instructions for use
Charging the lamp with cable: Insert the Type-C USB plug into the slot near the bottom
of the lamp. Plug any adapter for a mobile devise (with a USB-A output) into the wall
socket. Depending on the wattage of your adapter, charging will take approximately 2-3
hours.
Charging the lamp wirelessly: Place your Humble on any Qi-standard charging dock.
Depending on the wattage of your adapter, charging will take approximately 3-4 hours.
There are three indicator lights located next to the Type-C USB slot. While the battery is
charging; the lights will flash in order for 10 seconds. LED 1 flashing: battery level is 6%-
33%. LED 2 flashing: battery level is 34%-66%. LED 3 flashing: battery level is 67%-95%.
If the battery is fully charged, all three LEDs will remain lit.
3
Starting position: the lamp is switched off. Press the +button once: the light will turn on
at low brightness (candle). Press it a second time: medium brightness (ambient). Press it a
third time: full brightness (work). Press it a fourth time: the light will switch off.
Each time the brightness settings are adjusted, the lamp will show its current battery
level for 10 seconds. If you've purchased a Humble remote, you can find these brightness
settings as physical buttons on the display, together with a battery indicator button.
Charge the lamp when it no longer lights up. If the battery does not charge, contact your
Humble dealer. Never try to replace the battery yourself.
Cleaning the lamp
Clean the lamp carefully with a damp cloth (if necessary with a gentle soap) and
dry carefully before turning back on. Do not use any cleaning products that contain
chemicals.
Replacing the battery
The Humble Two base contains a battery which cannot be replaced or disassembled by
anyone other than an official Humble reseller. It must be recycled or disposed separately
from household waste. Please contact your Humble reseller if you need a replacement
battery.
Trouble shooting
If the lamp does not work, check its connection with the adapter and check whether
the battery is charging. Never attempt to repair the lamp yourself. Please contact your
Humble dealer if you encounter any problems.
EN
4