Publicité
Les langues disponibles
Les langues disponibles
Troubleshooting
Problem
Excessive vibration.
The light is on, but the
fan does not work.
Both the light and
motor do not work.
Suction performance
reduced.
Works normally but
cooking smells linger.
This appliance respects laws of the suppression of radio interference. As the Manufacturer has a policy of
continuous product improvement, it reserves the right to adapt and carry out any modification considered
necessary without prior warning.
5059340445861_MNL_IN_V04.indb 69
5059340445861_MNL_IN_V04.indb 69
Possible cause
The appliance is not installed properly
on the brackets.
The fan blade is damaged.
The fan motor is not fixed tightly.
The fan blade is jammed.
The motor is damaged.
Light bulb blown.
Power connection loose.
Speed may be too low.
Aluminium filters are dirty.
Top vent might be obstructed.
Optional vent kit might be twisted.
The installation may not comply with
the manufacturers instructions.
Carbon filter is not fitted in recirculation
mode or is full of grease.
Solution
Take down the appliance and check it
is properly fixed.
Switch off the appliance. Repair to
be carried out by qualified service
personnel only.
Ring the customer helpline at the end
of the Care & maintenance section to
arrange an engineer visit.
Check power supply.
Select a higher speed.
Clean the aluminium filters. (See Care
and maintenance section).
Clear any obstruction.
Ensure that the vent kit is fitted
according to the manufacturer's
instructions.
The vent hose should be correct
diameter throughout with no reductions
or restriction. (See installation section).
Fit carbon filter or replace the carbon
filter (See Care and maintenance
section).
69
15/6/2022 11:11 AM
15/6/2022 11:11 AM
Publicité
