Orbegozo SEH 1800 Manuel D'instructions page 12

SEH 1800/1850
DESCRIPTION
A. Stand
B. Switch ON/OFF
C. Speed knob
D. Temperature knob
E. Filter
INSTALLATION
To install the bracket, first unscrew the screw above the light, as can be seen in pic.
Remove the back of the stand, you see two holes in the top and one in the bottom
central side. Place this piece in the desired location for installation, it is
recommended you a nearby plug, check it and mark the position of the screws with a
pencil or marker through the holes in the rear piece.
Drill holes in the wall with a drill, insert the wall plugs (they are included) into the hole. Place the bracket
back on and screw these to the wall with the screws provided. Place the front of the bracket on the back
and place the first screw.
Direct connection
Once removed the first front cover, unscrew the screw placed near to switch (1) to remove next cover and
show the cabling. Inside, you can find a power strip, where you have to disconnect the cord to main
network (2) (to the plug).
Place the support on the wall as it explains in last paragraph but concurring the cord outlet of installation
with the upper hole of the support (3) (see the pic).
12