SUHNER ABRASIVE FHA 7 Dossier Technique page 21

2.2 r
Ating dAtA
Connection
Maximum speed
Maximum collet chuck
Weight
Vibration EN 60745
Max. wheel diameter
Max. torque
The specified vibration value was measured with a
standardised test method and may differ from the
actual operating value. The specified value can be
used for product comparisons or for an introductory as-
sessment of work breaks.
2.3 O
perAting cOnditiOns
Temperature range during operation: 0 to +50°C
Relative air humidity: 95% at +10°C not condensed
3. handling / Operation
3.1 w
Orking instructiOns
To achieve an optimum grinding result, move grinding
tool uniformly back and forth with light pressure.
Excessive pressure lessens the working capability of the
hand tool, as well as the life of the grinding tool.
The hand tool is equipped with an mechanical overload
protection.
3.2 s On/Off
witching
Before switchin on the drive make sure that the lever is
disengaged.
Hold the hand tool firmly. Switch on the drive. At this posi-
tion there is no connection to the drive. With your other
hand push the cord connector guard against the hand
tool. While you are doing this the grinding tool is acceler-
ate to the set speed.
G22
20000min
-1
Ø8mm
0.500kg
12.4m/s , K=1.5m/s
2 2
55mm
1.5Nm
Press and hold down the lever.
erating.
Switch off the drive when you stop working.
The tool still needs time to stop after the tool has been
switched off.
Put down the hand tool so that there can be no danger.
Remove the hand tool from the shaft.
4.1 p
4.2 r
If despite strict observance of the manufacturing and test-
ing method the hand tool should happen to fail, it must be
repaired by an authorized SUHNER agency.
4.3 w
In the event of the tool being improperly handled, used
for purposes for which it is not intended and/or of the ser-
vice and maintenance instructions not being observed by
non-authorized persons, no warranty shall be in effect for
damages/consequential damages.
Complaints can only be honored if the hand tool is re-
turned in the undisassembled condition.
4.4 s
Temperature range during operation: -15°C to +50°C
Max. relative air humidity: 90% at +30°C, 65% at +50°C.
4.5 d
This hand tool consists of materials which can be dis-
posed of in a recycling process.
Before disposal, render the hand tool unusable.
Conduct the test run without load for at least thirty
seconds. Do not use vibrating grinding tools.
You must always hold the hand tool when it is op-
4. Service / Maintenance
reVentiVe mAintenAnce
Always keep the hand tool clean and in a dry
place.
Worn chucks must be replaced.
epAir
ArrAnty
tOrAge
/ e
ispOsAl nVirOnmentAl cOmpAtiBility
21