Télécharger Imprimer la page

Whirlpool WHISPURE APR45130L Guide D'utilisation Et D'entretien page 5

Publicité

Les langues disponibles

Les langues disponibles

Using the Control Panel
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
1. Plug into a grounded 3 prong outlet.
NOTE: Both filter indicator lights will flash once during a self-
test when the air purifier is turned on or after a power
interruption.
2. Press POWER to turn on the air purifier.
3. Press SPEED to choose the desired fan speed.
4. Press POWER to turn off the air purifier.
LCD Display
PRE
HEPA
REPLACE
AIR QUALITY
NEW
NEW
A. Sleep Mode icon
B. VOC icon
C. Fan speed icon
Fan Speed
Press SPEED until the indicator light comes on for the desired
speed.
Fan Speed
Result
Low
Best product sound
Medium
Slower cleaning power
High
Maximum cleaning power
A
B
GOOD
MODERATE
POOR
Sleep Mode
Press SLEEP MODE to set. Sleep Mode runs on Low fan speed
for 8 hours and then returns to previously selected setting. To exit
before 8 hours, press SLEEP MODE, SPEED, or POWER.
Filter Status Lights
The pre-filter and HEPA filter status lights on the LCD display will
help you to determine when to change your filters. The status
indicator lights will move up from New to Replace at preset
intervals. When the Replace status has been reached, and the
Replace status light is flashing, replace the filter as indicated. See
"Filter Replacement" in the "Air Purifier Care" section.
VOC Sensor
Press AUTO on the control panel to automatically start the fan or
set the fan speed based on the quality of the air detected by the
Volatile Organic Compound (VOC) Sensor.
The VOC LED and icon are displayed on the air purifier control
panel display.
C
HR
1. Press ON • OFF to turn on the air purifier.
2. Press SLEEP MODE to choose Sleep mode.
3. Press SPEED to choose the desired fan speed.
4. Press the Timer Adjustment plus "+" or minus "-" button to
set the timer from 1 to 18 hours.
Using the Remote Control
5

Publicité

loading