Environmental Protection; Technical Specifications - Metabo RSG 18 LTX 15 Notice Originale

Order no.: 5.2 Ah 6.25392 (Li-Power)
etc.
Order no.: 4.0 Ah 6.25367 (LiHD)
Order no.: 5.5 Ah 6.25368 (LiHD)
etc.
For a complete range of accessories, see
www.metabo.com or the catalogue.
11. Repairs
Repairs to devices must be carried out by
qualified electricians only!
Please contact your Metabo service centre if you
have Metabo devices that require repairs. For
addresses see www.metabo.com.
You can download a list of spare parts from
www.metabo.com.

12. Environmental Protection

Observe national regulations on environmentally
compatible disposal and on the recycling of disused
machines, packaging and accessories.
Battery packs may not be disposed of with regular
waste. Return faulty or used battery packs to your
Metabo dealer!
Do not allow battery packs to come into contact with
water!
Protect the environment, and do not dispose
of devices and battery packs with household
waste. Observe national regulations on
separated collection and recycling of disused
machines, packaging and accessories.
Before disposal, discharge the battery pack in the
tool. Prevent the contacts from short-circuiting (e.g.
by protecting them with adhesive tape).

13. Technical Specifications

Explanatory notes regarding the specifications on
page 4.
Changes due to technological progress reserved.
U = voltage
A = dimensions (length x width x height)
P = operating pressure
T = permissible ambient temperature during
operation and storage
V = max. fill content
U = voltage (motor of the diaphragm pump)
M
l = length of the hosepipe
1
l = length of the spraying lance
2
G = thread of the regulating nozzle
m = weight (with the smallest battery pack)
Measured values determined in conformity with EN
62841.
direct current
The technical specifications quoted are subject to
tolerances (in compliance with the relevant valid
standards).
Emission values
These values make it possible to assess the
emissions from the device and to compare different
devices. The actual load may be higher or lower
depending on the operating conditions, the
condition of the device or the accessories. Please
allow for breaks and periods when the load is lower
for assessment purposes. Arrange protective
measures for the user, such as organisational
measures based on the adjusted estimates.
Vibration total value (vector sum of three directions)
determined in accordance with EN 62841:
a = vibration emission value
h
K = uncertainty (vibration)
h
Typical A-weighted sound levels:
L = sound-pressure level
pa
K = uncertainty (noise level)
pA
During operation the noise level can exceed 80
dB(A).
Wear ear protectors!
ENGLISH en
13